2 Transister (C945) tone control Stereo.

This circuit Tone Control Stereo, 2 Transister : C945 = 2 part.
Supply Volt min 12V <80mA .
Easy to build, PCB small.
Circuit 2 Transister (C945) tone control Stereo.

PCB 2 Transister (C945) tone control Stereo.

2 Transister (C945) tone control mono.

This circuit Tone Control Mono, 2 Transister : C945 = 2 part.
Supply Volt min 12V <50mA .
Easy to build, PCB small.
Circuit 2 Transister tone control mono.
PCB 2 Transister tone control mono.

Tone control circuits

Tone control circuits are electronic circuits used to modify an audio signal before it is fed to speakers, headphones or recording devices by way of an amplifier. They are akin to and sometimes called filters. In their most basic form, they elevate or attenuate the high and low frequencies of the signal. This is called treble or bass boost or cut, respectively, in the vernacular of audio engineering. More elaborate tone control circuits can elevate or attenuate the middle range of frequencies too. Really elaborate tone controls provide elevation or attenuation in 1/3 octave bands spanning from approximately 30 Hz to 18 kHz. These units are called graphic equalizers because their controls are in the form of sliders that are arranged so as to graphically display the amount of boost or cut being applied at any frequency of interest. The most elaborate units can control not only the boost and cut but also the frequency at which the boost and cut takes place and the bandwidth of the control's action. These are called parametric equalizers because they control all of the equalization parameters.

Read More : Tone control circuits

Pre MIC 3 Transister ( C945 ) mono

This circuit Dynamic Microphone Preamp,Pre MIC 3 Transister mono.
By Transister Part C945= 3 part.(TR1-TR3) OR C828 OR C458
Supply Volt 12V - 24V.
Easy to build and low cost.
Circuit Pre MIC - 3 Transister (C945) mono
PCB Pre MIC - 3 Transister (C945) mono

Pre MIC - 3 Transister (C945) mono

This circuit Dynamic Microphone Preamp,Pre MIC 3 Transister mono.
By Transister Part C945= 3 part.(TR1-TR3) OR C828 OR C458
Supply Volt 12V - 24V.
Easy to build and low cost.

Circuit Pre MIC - 3 Transister (C945) mono PCB Pre MIC - 3 Transister (C945) mono

Pre MIC 2 Transister mono

This circuit Pre MIC 2 Transister mono.

By Transister Part C945.
Supply Volt 12V - 24V.
Easy to build and low cost.

View Circuit and PCB Pre MIC 2 Transister mono

TDA2005 Mono Power Amp 20W BCL

This circuit use IC TDA2005 ,Car amplifier 10W BCL circuit.
For supply volt 12V battery car.

Read more and View Circuit
PCB - TDA2005 Mono Power Amp 20W